Siemens SINUMERIK 840D sl Series Diagnostics Manual page 849

08/2005
Reactions: - NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Change the position controller pulse rate on the NC.
Program Con- Switch control OFF - ON.
tinuation:
300706
Axis %1 drive %2 monitoring cycle time invalid
Parameters: %1 = NC axis number
%2 = Drive number
Definitions: Monitoring cycle MD 1002: $MD_MONITOR_CYCLE_TIME is invalid.
Reactions: - NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. See Drive Functions
"FB/DB1".
Program Con- Switch control OFF - ON.
tinuation:
300707
Axis %1 drive %2 basic cycle times of axes differ
Parameters: %1 = NC axis number
%2 = Drive number
Definitions: In a 2-axis module, the basic drive cycle for the two axes is not the same. This alarm can
only occur with OEM users who have the 611D drive without the standard NCK interface.
This makes it possible for axially different basic drive cycles to be transferred to the 611D
modules.
Reactions: - NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Set the same basic drive
cycle for both axes.
Program Con- Switch control OFF - ON.
tinuation:
300708
Axis %1 drive %2 current controller cycle times of axes differ
Parameters: %1 = NC axis number
%2 = Drive number
Definitions: The current controller cycle MD 1000: $MD_CURRCTRL_CYCLE_TIME must be identi-
cal for both axes on 2-axis modules.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-849