Siemens SINUMERIK 840D sl Series Diagnostics Manual page 509

08/2005
Reactions: - Alarm display.
Remedy:
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
62103
Channel %1 Block %2: No finishing allowance programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No finishing allowance is programmed, although it is necessary for this machining.
Reactions: - Alarm display.
Remedy: Programm a finishing allowance.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
62104
Channel %1 Block %2: Drilling cycle incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reactions: - Alarm display.
Remedy:
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
62105
Channel %1 block %2: Number of columns or lines equals zero
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE801.
Remedy: Check parameters _NUM1 and _NUM2.
62106
Channel %1 block %2: incorrect value for monitoring status in tool monitoring
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reactions: - Alarm display.
Remedy:
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
62107
Channel %1 block %2: parameter %4 incorrectly defined for tool monitoring in
cycles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reactions: - Alarm display.
Remedy:
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
62108
Channel %1 block %2: error in function Tool monitoring in cycles
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-509