Siemens SINUMERIK 840D sl Series Diagnostics Manual page 436

Overview of Alarms
Parameters: %1 = Channel number
%2 = Axis
Definitions: A PLC axis has not yet reached its end position and cannot be returned to a channel or
neutralized. This alarm should not occur when PLC data block FC18 is used.
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Wait until the axis has reached the end position or terminate the movement with delete
distance to go.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
60000
Channel %1 block %2:
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: --
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61000
Channel %1 block %2 no tool compensation active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: LONGHOLE, SLOT1, SLOT2, POCKET1 to
POCKET4, CYCLE71, CYCLE72, CYCLE90, CYCLE93 to CYCLE96.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: D-correction must be programmed before the cycle call.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61000
Channel %1 block %2: No tool offset active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: LONGHOLE, SLOT1, SLOT2, POCKET1 through
POCKET4, CYCLE71, CYCLE72, CYCLE90, CYCLE93 through CYCLE96.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: D-correction must be programmed prior to cycle call.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61001
Channel %1 block %2: Thread lead incorrectly defined
2-436
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005