Siemens SINUMERIK 840D sl Series Diagnostics Manual page 194

Overview of Alarms
Definitions: No further explanation.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14114
Channel %1 block %2 programmed tilt angle too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No further explanation.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14115
Channel %1 block %2 illegal definition of workpiece surface
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The surface normal vectors programmed at the beginning of block and at the end of block
point in opposite directions.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14116
Channel %1 block %2 absolute orientation programmed while ORIPATH/ORIPATHS
is active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The orientation has been entered as an absolute value (e.g. by a direction vector or a
rotation vector), although ORIPATH or ORIPATHS are active. When ORIPATH/ORI-
PATHS is active, the orientation is determined from the lead angle, tilt angle and angle of
rotation relative to the path tangent and surface normal vector.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14117
Channel %1 block %2 no angle or direction of the cone programmmed
Parameters: %1 = Channel number
%2 = Block number, label
2-194
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005