Siemens SINUMERIK 840D sl Series Diagnostics Manual page 576

Overview of Alarms
Remedy: --
105030
Please wait, renumbering in progress (%1)!
Parameters: %1 = --
Definitions: The part program's blocks are serially numbered.
Remedy: --
105031
Renumbering has been aborted !
Definitions: Renumbering of the part program was aborted.
Insufficient part program memory may be the cause of the error.
Remedy: --
105032
Renumbering finished !
Definitions: Renumbering of the part program was completed without errors.
Remedy: --
105033
Renumbering incomplete, max. block length exceeded (%1)
Parameters: %1 = --
Definitions: --
Remedy: --
105041
Block number will be too large !
Definitions: The set increment and the size of the program cause the block number to be greater than
999999.
Remedy: --
105042
Block number not allowed !
Definitions: The first block number is less than 0 or greater than 999999.
Remedy: --
105043
Increment not allowed !
Definitions: The increment was entered as a negative.
Remedy: --
105050
Please wait: graphics being output !
Definitions: The help displays are being prepared for display.
Remedy: --
105051
%1
Parameters: %1 = --
Definitions: The dynamic long texts for the cycle parameterization are output here.
Remedy: --
105052
Error in description of cycles of %1 !
Parameters: %1 = --
Definitions: The cycle description sc.com, uc.com contains a line that cannot be interpreted.
This line is output via <xxx>.
Remedy: --
105053
No cycle available in current line !
Definitions: The editor's cursor is in a line that does not contain a cycle.
2-576
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005