Siemens SINUMERIK 840D sl Series Diagnostics Manual page 207

08/2005
- NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14196
Channel %1 block %2 error %3 on interpreting the contents of $SC_CUTDIRMOD
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Error code
Definitions: An error has occured on interpreting the string contained in setting data
$SC_CUTDIRMOD. This setting data is always read when a new edge is selected. The
error code indicates the error cause:
1: The string only consists of blanks or a sign
2: Unknown frame name after $P_
3: No colon after the first valid frame name
4: Insufficient memory space on internal creation of a frame
5: Invalid frame index
6: Further characters found after complete string
7: Second frame name after colon is missing
8: Impermissible frame rotation (surface normals are rotated against each other by 90
degrees or more)
9: Invalid frame chain (the first frame must be in front of the second frame in the frame
chain)
10: Invalid axis name
11: Axis is no rotary axis
20: Invalid angle indicated (numerical value)
30: Invalid angle of rotation (no integer multiple of 90 degrees)
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Enter valid string in setting data $SC_CUTDIRMOD.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14197
Channel %1 block %2 D number and H number programmed simultaneously
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A D word and H word have been programmed simultaneously.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14198
Channel %1 block %2 illegal change of tool direction with tool offset
Parameters: %1 = Channel number
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-207