Siemens SINUMERIK 840D sl Series Diagnostics Manual page 448

Overview of Alarms
- Interpreter stop
Remedy: Program lower spindle speed/raise reference plane.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61127
Channel %1 block %2: Wrong definition of tapping axis transformation ratio
(machine data)
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Check machine data 31050 and 31060 in the appropriate gear stage of the drilling axis.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61128
Channel %1 block %2: Plunge angle = 0 for insertion with oscillation or helix
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: SLOT1.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Check parameter _STA2.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61129
Channel %1 block %2: perpendic. approach and retraction during contour milling
only allowed with G40
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE72.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61130
Channel %1 block %2: positions of parallel axes cannot be compensated. No work-
piece reference agreed.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE69.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
2-448
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005