Siemens SINUMERIK 840D sl Series Diagnostics Manual page 204

Overview of Alarms
%2 = Block number, label
Definitions: If a tool carrier selection causes a change in the table offset, a valid base frame must be
defined in order to store this offset; for more information see machine data 20184
(TOCARR_BASE_FRAME_NUMBER).
Reactions: - Correction block is reorganized.
- Interpreter stop
- Interface signals are set.
- Alarm display.
Remedy: Change the NC program or machine data 20184 (TOCARR_BASE_FRAME_NUMBER).
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14156
Channel %1 toolholder selection error at reset
Parameters: %1 = Channel number
Definitions: The settings in RESET_MODE_MASK require that an active orientable toolholder is
maintained after the reset. This is done by deselecting the old orientable toolholder and
then reselecting it with data that may have been modified. If an error occurs during the
reselection, this alarm is issued (as a warning) and then an attempt is made to select the
orientable toolholder in the initial setting. If this second attempt is successful, the reset
cycle is continued without any further alarms.
Typically, the alarm only occurs when the old orientable toolholder has been selected with
TCOFR, and its axis directions have been changed in such a way before the reset that a
setting suitable for the associated frame is no longer possible. If there is another cause for
the alarm, this results in an alarm also being issued when attempting to select in the initial
setting. This is then also displayed in plain text.
Reactions: - Alarm display.
Remedy: Check the program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14157
Channel %1 block %2 illegal interpolation type with MOVT
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Linear or spline interpolation must be active with MOVT (G0, G1, ASPLINE, BSPLINE,
CSPLINE).
Reactions: - Correction block is reorganized.
- Interpreter stop
- Interface signals are set.
- Alarm display.
Remedy: Modify program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14159
Channel %1 block %2 more than two angles programmed with ROTS or AROTS
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Frame rotations are described using space angles with the language commands ROTS or
AROTS. A maximum of two angles can be programmed.
Reactions: - Correction block is reorganized.
- Interpreter stop
- Interface signals are set.
- Alarm display.
2-204
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005