Siemens SINUMERIK 840D sl Series Diagnostics Manual page 452

Overview of Alarms
Remedy: Enter shorter text length.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61178
Channel %1 block %2: code page not present
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified code page is not supported by the cycle.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Use code page 1252.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61179
Channel %1 block %2: character does not exist, no.: %4
Parameters: %1 = Channel number
%2 = Block number, label
%4 = Character number
Definitions: The character entered in the text for engraving cannot be milled.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Enter another character.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61180
Channel %1 block %2: no name assigned to swivel data block, although MD
$MN_MM_NUM_TOOL_CARRIER > 1
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Although there are several swivel data blocks, no unique names have been assigned.
Alarm triggered by following cycles: CYCLE800.
Remedy: Assign unique names for swivel data blocks.
61181
Channel %1 block %2: Insufficient NCK software version (TOOLCARRIER function-
ality missing)
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Swivelling is not possible with the current NCK software version. Alarm triggered by fol-
lowing cycles: CYCLE800.
Remedy: Upgrade NCK software; functionality TOOLCARRIER available in NCU 6.3xx and higher.
61182
Channel %1 block %2: Name of swivel data record unknown
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: the specified name of the swivel data block is unknown. Alarm triggered by following
cycles: CYCLE800.
Remedy: Check the name of the swivel data block.
2-452
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005