Siemens SINUMERIK 840D sl Series Diagnostics Manual page 171

08/2005
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12600
Channel %1 block %2 invalid line checksum
Parameters: %1 = Channel number
%2 = Block number
Definitions: On processing an INI file or when executing a TEA file, an invalid line checksum has been
detected.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Correct INI file or correct MD and create new INI file (via "upload").
Program Con- Switch control OFF - ON.
tinuation:
12610
Channel %1 block %2 accessing single character with call-by-reference parameter
not possible %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source string
Definitions: An attempt has been made to use a single character access for a call-by-reference
parameter.
Reactions: - Correction block
- Interface signals are set.
- Alarm display.
Remedy: Temporarily store single characters in user-defined CHAR variable and transfer this.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12620
Channel %1 block %2 accessing this variable as single character not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source string
Definitions: The variable is not a user-defined variable. The single character access is only allowed
for user-defined variables (LUD/GUD).
Reactions: - Correction block
- Interface signals are set.
- Alarm display.
Remedy: Temporarily store variable in user-defined STRING, process this and put back into stor-
age.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12630
Channel %1 block %2 skip ID/label in control structure not allowed
Parameters: %1 = Channel number
%2 = Block number
Definitions: Blocks with control structures (FOR, ENDIF, etc.) cannot be concealed and must not con-
tain any labels.
Reactions: - Correction block
- Interface signals are set.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-171