Siemens SINUMERIK 840D sl Series Diagnostics Manual page 511

08/2005
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
62185
Channel %1 block %2 : angle adapted to angle grid: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Remedy: Check installation and start-up of the swivel cycle CYCLE800.
62186
Channel %1 Block %2: Swiveling in JOG --> active WO G%4 and basic frames con-
tain rotations
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Note for 62186 and 62187:
Set and active error messages 62186 and 62187 with GUD7 parameter _TC_FR:
100th position 0xx -> no error analysis 62186 61287
1xx -> error analysis 62186 - active WO G%4 and basic frames include rotations
2xx -> error analysis 62187 - several active basic frames (G500) include rotations
3xx -> error analyses 62186 and 62187.
Remedy: For %4 of the active WO see notes for 62186 and 62187.
62187
Channel %1 Block %2: Swiveling in JOG --> several active basic frames (G500)
contain rotations
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Several active basic frames (G500) include rotations.
Alarm triggered by following cycle: CYCLE800.
Remedy: See notes for 62186 and 62187.
62200
Channel %1 Block %2: Start spindle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Stop prior to thread machining, as the spindle is in stop position.
Alarm triggered by following cycles: ASUP, E_TR_CON, F_TR_CON.
Remedy: Start the tool spindle before machining the thread.
62201
Channel %1 block %2: Z offset does not influence the retraction planes.
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-511