Siemens SINUMERIK 840D sl Series Diagnostics Manual page 586

Overview of Alarms
Parameters: %1 = Line number
Definitions: The step is not an element of ManualTurn.
Easystep sequencer is not loaded.
Reactions: - Alarm display.
Remedy: Delete the program step or change the program in the operating area PROGRAMS in the
SINUMERIK 840D or 810D (CNC mode).
Program Con- Internal
tinuation:
111002
Not enough memory space. Abort in line %1
Parameters: %1 = Line number
Definitions: Easystep sequencer has too many steps.
Easystep sequencer is not loaded.
Reactions: - Alarm display.
Remedy: Change the program in the operating area PROGRAMS in the SINUMERIK 840D or
810D (CNC mode).
Program Con- Internal
tinuation:
111003
ManualTurn: %1
Parameters: %1 = Error code
Definitions: Internal system message over the ManualTurn operator panel.
Reactions: - Alarm display.
Remedy: Acknowledge error and inform Siemens.
Program Con- Internal
tinuation:
111004
File does not exist or is faulty %1
Parameters: %1 = File/Contour name
Definitions: Easystep sequencer cannot interpret a step with contour programming.
Contour not in the directory.
Reactions: - Alarm display.
Remedy: Load contour into the directory.
Program Con- Internal
tinuation:
111005
Error when interpreting the contour %1
Parameters: %1 = Contour name
Definitions: Contour is faulty.
Reactions: - Alarm display.
Remedy: Check the contour's machining sequence.
Program Con- Internal
tinuation:
111006
Maximum number of contour elements exceeded %1
Parameters: %1 = Contour name
Definitions: The maximum permissible number of 50 contour elements was exceeded when interpret-
ing the machining sequence of a contour.
Reactions: - Alarm display.
Remedy: Check the contour's machining sequence and, if necessary, edit it.
2-586
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005