Siemens SINUMERIK 840D sl Series Diagnostics Manual page 212

Overview of Alarms
5: The axis is a reciprocating axis with axial handwheel override; the reciprocating move-
ment cannot be
started immediately as the handwheel performs a DRF movement for this axis
6: The DRF movement for this axis cannot be executed as an axial handwheel override is
active for
this axis with the handwheel
7: The DRF movement for this axis cannot be executed as a velocity override of the path
with
the handwheel is active and the axis belongs to the path
8: The DRF movement for this axis cannot be executed as the contour handwheel is
active with
this handwheel and the axis belongs to the path
9: The DRF movement for this axis cannot be executed as the axis is a PLC axis with
handwheel
override that is active with this handwheel
10: The DRF movement for this axis cannot be executed as the axis is active as recipro-
cating axis
with handwheel override with this handwheel
Reactions: - Alarm display.
Remedy: Use the handwheel for one purpose at a time only.
Program Con- Alarm display showing cause of alarm disappears. No further operator action necessary.
tinuation:
14400
Channel %1 block %2 tool radius compensation active at transformation switcho-
ver
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A change of transformation is not allowed when tool radius compensation is active.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Perform tool radius compensation in the NC part program with G40 (in a block with G00 or
G01) before performing a transformation change.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14401
Channel %1 block %2 transformation not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The required transformation is not available.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Please inform the authorized personnel/service department.
• Modify part program; program defined transformations only.
• Check MD 24100 TRAFO_TYPE_n (assigns the transformation to part program instruc-
tions).
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
2-212
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005