Siemens SINUMERIK 840D sl Series Diagnostics Manual page 492

Overview of Alarms
%2 = Block number, label
Definitions: The programmed radius of the machined part is too small. Alarm triggered by following
cycles: CYCLE94, CYCLE96.
Remedy: Check parameter SPD or DIATH.
61602
Channel %1 block %2: Tool width incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Plunge cutter is larger than the programmed groove width. Alarm triggered by following
cycle: CYCLE93.
Remedy: Check tool or change program.
61603
Channel %1 block %2: Recess type incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Radii/chamfers at the groove base do not match the groove width. Face groove on a con-
tour element running parallel to the longitudinal axis is not possible. Alarm triggered by
following cycle: CYCLE93.
Remedy: Check parameter VARI.
61604
Channel %1 block %2: Active tool violates programmed contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Contour violation in the relief cut elements due to the tool clearance angle of the tool
used. Alarm triggered by following cycle: CYCLE95.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Use a different tool or check the contour subroutine.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61605
Channel %1 block %2: Contour incorrectly programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Illegal relief cut element detected. Alarm triggered by following cycles: CYCLE76,
CYCLE77, CYCLE95.
Remedy: Check contour program.
61606
Channel %1 block %2: Error during contour preparation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An error has been found on conditioning the contour. This alarm is always related to one
of NCK alarms 10930...10934, 15800 or 15810. Alarm triggered by following cycle:
CYCLE95.
Remedy: Check contour subroutine.
61607
Channel %1 block %2: Starting point incorrectly programmed
Parameters: %1 = Channel number
%2 = Block number, label
2-492
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005