Siemens SINUMERIK 840D sl Series Diagnostics Manual page 508

Overview of Alarms
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61988
Channel %1 block %2: Program name for pocket milling missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61989
Channel %1 block %2: D1 is not programmed as active tool cutting edge
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
62000
Channel %1 block %2:
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: --
Reactions: - Alarm display.
Remedy: --
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
62000
Channel %1 block %2: Insert new tool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: .
Reactions: - Alarm display.
Remedy: --
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
62100
Channel %1 block %2: No drilling cycle active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No modal drilling cycle has been called before the drilling pattern cycle call. Alarm trig-
gered by following cycles: HOLES1, HOLES2.
Remedy: Check whether a drilling cycle was called prior to calling the drilling pattern cycle.
62101
Channel %1 Block %2: Milling direction incorrect - G3 is generated
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Synchronous or reverse rotation programmed. But the spindle does not rotate at a cycle
call.
Remedy: Check value in paramter CDIR.
62102
Channel %1 Block %2: pocket not completely solidly machined during finishing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
2-508
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005