Block Number, Label Channel Number - Siemens SINUMERIK 840D sl Series Diagnostics Manual

08/2005
61706
Channel %1 block %2: Internal cycle error while generating checksum
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61707
Channel %1 block %2: internal cycle error with ACTIVATE at HMI
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61708
Channel %1 block %2: internal cycle error with READYPROG at HMI
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61709
Channel %1 block %2: Timeout in contour calculation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
61710
Channel %1 block %2: Stock removal program not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Internal
tinuation:
61711
Channel %1 block %2: Name of stock removal program missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-495