Siemens SINUMERIK 840D sl Series Diagnostics Manual page 77

08/2005
Remedy: • Delete or unload directory (e.g. workpiece), or
• Increase $MM_NUM_DIR_IN_FILESYSTEM.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
6550
Too many subdirectories
Definitions: The number of subdirectories in a directory of the NCK has reached the maximum limit.
Reactions: - Alarm display.
Remedy: Please inform the authorized personnel/service department.
• Delete or empty subdirectories in the respective directory, or
• Increase $MM_NUM_SUBDIR_PER_DIR.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
6560
Data format not allowed
Definitions: An attempt was made to write impermissible data in an NCK file. This error can occur in
particular when the attempt was made to load binary data in the NCK as ASCII file.
The error can also occur during preprocessing of cycles (see
$MN_PREPROCESSING_LEVEL) if the NC block is very long. In this case, subdivide the
NC block.
Reactions: - Alarm display.
Remedy: Specify that the file concerned is a binary file (e.g. extension: .BIN).
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
6570
NC memory full
Definitions: The NC card file system of the NCK is full. The task cannot be executed. Too many sys-
tem files were created in the DRAM.
Reactions: - Alarm display.
Remedy: Start fewer "execute from external" processes.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
6580
NC memory full
Definitions: The NC card file system of the NCK is full. The task cannot be executed. To many files
have been loaded
Reactions: - Alarm display.
Remedy: Delete or empty files (e.g. part programs).
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
6600
NC card memory is full
Definitions: The NC card file system of the NCK is full. No more data can be stored on the NC card.
Reactions: - Alarm display.
Remedy: Delete the data on the PCMCIA card.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
6610
Too many files open on NC card
Definitions: Too many files are being accessed simultaneously on the NC card.
Reactions: - Alarm display.
Remedy: Repeat the action later.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-77