Siemens SINUMERIK 840D sl Series Diagnostics Manual page 564

Overview of Alarms
Definitions: The tool cannot be deleted. It may currently be active.
Remedy: --
104012
No master spindle available
Definitions: No master spindle was configured.
Remedy: Configure a master spindle via the machine data.
104013
Error on deleting area
Definitions: --
Remedy: --
104014
Incorrect input
Definitions: The entered value is impermissible, e.g., it lies outside the input limits.
Remedy: Please observe the value range.
104015
Number of parameters per tool edge is zero
Definitions: The number of parameters per cutting edge was not configured.
Remedy: Configure the number of parameters per cutting edge via the machine data.
104016
No spindles available
Definitions: No spindle was configured.
Remedy: Configure a spindle via the machine data.
104017
No settable frame currently active
Definitions: --
Remedy: --
104018
Tool not available
Definitions: The specified tool does not exist.
Remedy: --
104019
Tool type not available
Definitions: The specified tool type does not exist.
Remedy: Specify a valid tool type.
104020
No empty location found
Definitions: There is no empty location with the specified search parameters.
Remedy: Correct search parameters.
104021
Error on searching for empty location
Definitions: --
Remedy: --
104022
Error in present location search
Definitions: --
Remedy: --
104023
Error in Tool Load
Definitions: An error occurred while a tool was being loaded; the procedure has been aborted.
Remedy: Check loader.
2-564
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005