Siemens SINUMERIK 840D sl Series Diagnostics Manual page 191

08/2005
Remedy: Please inform the authorized personnel/service department. Check the transferred
parameters (axis name) of the function AXNAME to determine whether a geometry, chan-
nel or machine axis of this name has been configured by means of the machine data:
10 000: AXCONF_MACHAX_NAME_TAB
20 070: AXCONF_GEOAX_NAME_TAB
20 080: AXCONF_CHANAX_NAME_TAB
Select the transfer string in accordance with the axis name and change the axis name in
the machine data if necessary. (If a change of name is to take place via the NC part pro-
gram, this change must first be validated by means of a "Power On").
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14098
Channel %1 block %2 conversion error: no valid number found
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The string is not a valid INT or REAL number.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program. If it is an entry, then you can check whether the string is a number
via the preset function ISNUMBER (with the same parameter).
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14099
Channel %1 block %2 result in string concatenation too long
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The result of string chaining returns a string which is greater than the maximum string
length laid down by the system.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Adapt part program. With the function STRLEN, it is also possible to test the size of the
sum string before performing the chaining operation.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14100
Channel %1 block %2 orientation transformation not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Four transformation groupings (transformation types) can be set for each channel via
machine data. If the keyword TRAORI(n) (n ... number of the transformation grouping) is
used to address a transformation grouping for which the machine data is not defaulted,
the alarm message will be triggered.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-191