Siemens SINUMERIK 840D sl Series Diagnostics Manual page 596

Overview of Alarms
Remedy: Make room in the memory, e.g. by deleting an old program. Select "Renumber" again.
Program Con- Internal
tinuation:
112200
The contour is a step in the current program%nsequence. Machining not enabled
Definitions: The contour is an element from a loaded program and cannot be deleted or renamed.
Reactions: - Alarm display.
Remedy: Remove the contour from the loaded program.
Program Con- Internal
tinuation:
112201
Contour is step in current automatic chain%nMachining not possible.
Definitions: The contour is an element of a program loaded under "Machine auto" and cannot be
deleted or renamed.
After the program has been started, the integrated contours cannot be changed under
"Program" while the program is running.
Reactions: - Alarm display.
Remedy: Stop the program and load it under "Program". Remove the contour from the program.
Program Con- Internal
tinuation:
112210
Tool axis cannot be changed. Not enough NC-%nmemory.
Definitions: If the tool axis is reselected, the NC program has to be generated again. Hereby the old
NC program is saved first.
Then the new program is generated. Here, the NC memory is insufficient to save the new
program.
The reselection of the tool axis was not carried out.
Reactions: - Alarm display.
Remedy: Free memory space must be created on the NC, and it must be enough for the program to
be processed (e.g. by deleting programs that are no longer required).
Program Con- Internal
tinuation:
112211
Tool preselection cannot be processed.%nNot enough NC memory.
Definitions: When tool preselection is processed, the NC program has to be generated again. Hereby
the old NC program is saved first.
Then the new program is generated. Here, the NC memory is insufficient to save the new
program.
The tool preselection is not processed.
Reactions: - Alarm display.
Remedy: Free memory space must be created on the NC, and it must be enough for the program to
be processed (e.g. by deleting programs that are no longer required).
Program Con- Internal
tinuation:
112300
Tool management concept 2 not possible%nMagazine not completely loaded.
Definitions: The magazine is not completely loaded with tools.
In the magazine of tool management type 2, the number of tools specified in machine
data 18082 has to be created.
Reactions: - Alarm display.
Remedy: Installation and start-up: Create the correct number of tools.
2-596
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005