Siemens SINUMERIK 840D sl Series Diagnostics Manual page 216

Overview of Alarms
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis
Definitions: The axis is to be traversed as an indexing axis, but a frame is active. This is not allowed
by machine data FRAME_FOR_CORRPOS_NOTALLOWED.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Please inform the authorized personnel/service department. Modify part program.
Change machine data CORR_OR_AXIS_NOT_ALLOWED.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14430
Channel %1 block %2 tangential axis %3 must not be traversed as POS axis
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Definitions: A tangentially followed-up axis cannot be traversed as positioning axis.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Change part program and delete active tangential control with TANGDEL.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14432
Channel %1 block %2 rounding length for tangential axis %3 is zero.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Definitions: For a tangential axis that is coupled during preparation, a rounding length must be indi-
cated with TANGON() on activating the tangential control, or possibly occuring discontinu-
ities of the tangential axis cannot be smoothed.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14434
Channel %1 block %2 rel. lift-off path for tangential axis %3 is invalid
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Definitions: Factor r as programmed on TLIFT for the relative lift-off path must be within range 0 =< r
< 1.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
2-216
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005