Siemens SINUMERIK 840D sl Series Diagnostics Manual page 97

08/2005
- NC Stop on alarm.
Remedy: More processor time must be allocated to the block preparation modules. Machine data
$MN_IPO_SYSCLOCK_TIME_RATIO or $MN_SYSCLOCK_CYCLE_TIME can be
increased for this purpose.
Program Con- Switch control OFF - ON.
tinuation:
10299
Channel %1 Auto-Repos function is not enabled
Parameters: %1 = Channel number
Definitions: The Auto-Repos function (operating mode) was selected in the channel but is not imple-
mented.
Reactions: - Alarm display.
Remedy: This message is purely informational.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10600
Channel %1 block %2 auxiliary function during thread cutting active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An auxiliary function output is programmed in a thread cutting block.
Reactions: - Alarm display.
Remedy: Consequential errors can occur if the machining path of the thread block is too short and
further blocks (thread blocks) follow in which no machining stop may occur.
Possible remedial measures:
• Program a longer path and/or a lower traversing rate.
• Output auxiliary function in another block (program section).
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10601
Channel %1 block %2 zero velocity at block end point during thread cutting
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: This alarm occurs only when several blocks with G33 follow in succession. The block end
velocity in the specified block is zero although a further velocity block follows. The rea-
sons for this can be, for instance:
• G9
• Auxiliary function after motion
• Auxiliary function output before the motion of the following block
• Positioning axis in the block
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Please inform the authorized personnel/service department. Modify the NC part program
by removing any programmed "Stop at end of block" G09.
Modify general machine data 11110 AUXFU_GROUP_SPEC [n] for selecting the output
time of an auxiliary function group by changing "Auxiliary function output before/after the
movement" to "Auxiliary function output during the movement".
Bit 5 = 1: Auxiliary function output before movement
Bit 6 = 1: Auxiliary function output during movement
Bit 7 = 1: Auxiliary function output after movement
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-97