Siemens SINUMERIK 840D sl Series Diagnostics Manual page 525

08/2005
Parameters: %1 = Channel number
Definitions: In JOG mode, the Yf axis is traversed. The value of the Yf axis is larger than the sum of
the arm lengths and the current tool length in the Z direction.
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Traverse Yf axis in JOG mode in opposite traversing direction
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
70004
Channel %1 block %2 Yf has been programmed larger than the effective arm length
Parameters: %1 = Channel number
%2 = Block number
Definitions: In the part program, one position in the Yf axis has been programmed larger than the
effective arm lengths
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
70010
Channel %1 block %2 unreachable point on selection
Parameters: %1 = Channel number
%2 = Block number
Definitions: On transformation selection, the machine axes are positioned with the joint rod not reach-
ing the platform.
This cannot happen with a machine that has been started up properly.
If the joints have not yet been connected with the platform on start-up, this alarm will show
an impermissible position of the machine axes.
Reactions: - Interpreter stop
- Alarm display.
Remedy: Modify machine data or approach other selection position
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
70011
Channel %1 block %2 unreachable point
Parameters: %1 = Channel number
%2 = Block number
Definitions: The selected block includes a position outside the possible working range of the machine
tool.
Reactions: - Local alarm reaction.
- Alarm display.
Remedy: Modify parts program
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-525