Siemens SINUMERIK 840D sl Series Diagnostics Manual page 221

08/2005
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Edge number, label
Definitions: No negative radii are permitted for contour tools, i.e. the sum of basic radius and wear
value must be at least 0.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Check tool definition. Change edge radius.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14549
Channel %1 block %2 contour tool: impermissible programming. Code no. %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Error code
Definitions: Impermissible programming has been found for contour tools on active tool radius com-
pensation. The error cause is explained in detail by the error code.
1: In G code group 17, KONT is active during activation
2: In G code group 17, KONT is active during deactivation
9: In G code group 40, CUTCONOF is not active
10: Reprogramming of G41 / G42 in already active tool radius compensation not permis-
sible
20: Circle with more than one rotation not permissible
21: Ellipse (circle not in compensation level)
23: Involute not permissible
24: Several polynomials not permitted in one block only. These blocks could be created
by e.g. COMPCAD or G643.
30: Preprocessing stop not permitted
41: Starting point of first compensation block cannot be reached by anyone of the defined
cutting edges
42: End point of last compensation block cannot be reached by anyone of the defined
cutting edges
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Change NC program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14550
Channel %1 block %2 contour tool: impermissible tool contour change. Code no.
%3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Error code
Definitions: A new tool with deviating tool contour was activated for contour tools on active tool radius
compensation
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-221