Siemens SINUMERIK 840D sl Series Diagnostics Manual page 535
Hide thumbs
Also See for SINUMERIK 840D sl Series:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
08/2005
75265
RCTR: channel: %1, block: %2, unreachable position on block editing
Parameters:
%1 = Channel number
%2 = Block number
Definitions:
On block editing a non-approachable position is detected:
Reactions:
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy:
Modify part program.
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
75270
RCTR: channel %1, tool parameters incorrect on interpolation
Parameters:
%1 = Channel number
Definitions:
On interpolation incorrect tool parameters are detected:
Reactions:
- NC Start disable in this channel.
- Alarm display.
- NC Stop on alarm.
Remedy:
Correct tool parameters.
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
75275
RCTR: channel: %1, block: %2, unreachable position on interpolation
Parameters:
%1 = Channel number
%2 = Block number
Definitions:
On block interpolation a non-approachable position is detected:
Reactions:
- NC Start disable in this channel.
- Alarm display.
- NC Stop on alarm.
Remedy:
Modify part program.
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
75500
Channel %1 HSLC: Wrong configuration
Parameters:
%1 = Channel number
Definitions:
Technology function "rapid cycle-independent switching with 2D path relation" has not
been parameterized correctly. There are two reasons for this alarm:
• No geometry axis has been defined
• The option "Software cam" is set.
Reactions:
- Alarm display.
- NC Stop on alarm.
Remedy:
Modify MD configuration.
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
75600
Channel %1 RESU: wrong MD configuration. Error code %2
Parameters:
%1 = Channel number
%2 = Error code
Definitions:
The following errors were detected in the machine data of the retrace support function
when ramping up:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-535
Hide quick links:
Advertisement
Chapters
Table of Contents
