Siemens SINUMERIK 840D sl Series Diagnostics Manual page 519

08/2005
%2 = Block number, label channel number
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
62919
Channel %1 block %2: Nominal radius parameter is missing
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
62920
Channel %1 block %2: Pocket surface not specified
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
62921
Channel %1 block %2: Pocket depth not specified
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
62922
Channel %1 block %2: Output program not specified
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-519