Siemens SINUMERIK 840D sl Series Diagnostics Manual page 502

Overview of Alarms
- Alarm display.
Remedy: --
Program Con- Internal
tinuation:
61807
Channel %1 block %2: Wrong spindle direction programmed (active)
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE840.
The programmed spindle direction contradicts the spindle direction planned for the cycle.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Check parameters SDR and SDAC.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61808
Channel %1 block %2: Final drilling depth or single drilling depth missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The total depth Z or individual drilling depth Q is missing from theG8xblock (initial cycle
call).
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Internal
tinuation:
61809
Channel %1 Block %2: Drill position not permissible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: --
Reactions: - Alarm display.
Remedy: --
Program Con- Internal
tinuation:
61810
Channel %1 Block %2: ISO G code not possible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In the call block an impermissible ISO axis name was programmed.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
2-502
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005