Siemens SINUMERIK 840D sl Series Diagnostics Manual page 259

08/2005
Position control (SPCON/SPCOF, spindle speed under S..., M3/M4/M5)
Axis mode:
Position control (M70/M3, M4, M5, axis position under user-selectable axis name)
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Check part program for correct spindle number.
With M3, M4 or M5 put the required spindle into control mode before calling the dwell
time.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16111
Channel %1 block %2 spindle %3 No speed programmed
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Spindle
Definitions: Programming of a speed is expected.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Program speed with S[spindle number]=..
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16112
Channel %1 block %2 following spindle %3 Impermissible programming
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Spindle
Definitions: With synchronous spindle-VV-coupling an additional motion for the following spindle can
only be programmed with M3, M4, M5 and S... The paths created by specified positions
cannot be maintained safely for a velocity coupling, especially if a position control is miss-
ing. If dimensional accuracy or reproducibility are not important, the alarm can be sup-
pressed with machine data 11410 SUPPRESS_ALARM_MASK Bit27 = 1.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Use synchronous spindle-DV-coupling or program direction of rotation and speed.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16120
Channel %1 block %2 invalid index for tool fine compensation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Mistake in programming: The 2nd parameter in the PUTFTOC command indicates for
which tool parameter the value is to be corrected (1 - 3 tool lengths, 4 tool radius). The
programmed value is beyond the permitted range.
Permissible values are 1 - 4 if on-line tool radius compensation is allowed (see machine
data ONLINE_CUTCOM_ENABLE), otherwise values 1 - 3.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-259