Siemens SINUMERIK 840D sl Series Diagnostics Manual page 299

08/2005
Remedy: Please inform the authorized personnel/service department. Modify part program or
machine data accordingly.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17130
Channel %1 block %2 analog output no. %3 not activated
Parameters: %1 = Channel number
%2 = Block number, label
%3 = No. of output
Definitions: An attempt has been made by means of the system variable $A_OUTA[n] to write or read
an analog output n that has not been activated by the MD 10310
FASTIO_ANA_NUM_OUTPUTS.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Please inform the authorized personnel/service department. Modify part program or
machine data accordingly.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17140
Channel %1 block %2 NCK output %3 is assigned to a function via machine data
Parameters: %1 = Channel number
%2 = Block number, label
%3 = No. of output
Definitions: The programmed digital/analog output is assigned to an NC function (e.g. software
cams).
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Please inform the authorized personnel/service department. Use another output or deac-
tivate concurrent NC function via MD.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17150
Channel %1 block %2 maximum of %3 NCK outputs programmable in the block
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Quantity
Definitions: No more than the specified number of outputs may be programmed in an NC block.
The quantity of hardware outputs is defined in the MDs:
10360 FASTIO_DIG_NUM_OUTPUTS and
10310 FASTIO_ANA_NUM_OUTPUTS
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Program fewer digital/analog outputs in a block. The specified maximum number applies
in each case separately for analog or digital outputs. If necessary, program two NC
blocks.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-299