Siemens SINUMERIK 840D sl Series Diagnostics Manual page 629

08/2005
Remedy: - change the configuration on this control unit.
- use an additional control unit.
201107 <location>CU: Save to CompactFlash Card unsuccessful
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: A data save on the CompactFlash Card was not able to be successfully carried-out.
- CompactFlash Card is defective.
- CompactFlash Card does not have sufficient memory space.
Fault value (r0949, decimal):
-1: The file on the RAM was not able to be opened.
-2: The file on the RAM was not able to be read.
-3. A new directory was not able to be set-up on the CompactFlash Card.
-4: A new file was not able to be set-up on the CompactFlash Card.
-5: A new file was not able to be written onto the CompactFlash Card.
Remedy: - try to save again.
- use another CompactFlash Card.
201110 <location>CU: More than one SINAMICS G on one control unit
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: More than one SINAMICS G power module type is being operated from the control unit.
Fault value (r0949, decimal):
Number of the second drive with a SINAMICS G power module type.
Remedy: Only one SINAMICS G drive type is permitted.
201111 <location>CU: SINAMICS S and G together on one control unit
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: SINAMICS S and G drive units are being operated together on one control unit.
Fault value (r0949, decimal):
Number of the first drive object with a different power module type.
Remedy: Only power modules of one particular drive type may be operated with one CU.
201120 <location>Terminal initialization has failed
Reaction: OFF1 (OFF2)
Acknowledge: IMMEDIATELY (POWER ON)
Cause: An internal software error has occurred when initializing the terminal functions on the
CU3xx, the TB30 or the TM31.
Fault value (r0949, hexadecimal):
Only for internal Siemens troubleshooting.
Remedy: - carry-out a POWER ON (power off/on) for all components.
- upgrade the firmware release.
- contact the Hotline.
- replace the control unit.
201122 <location>Frequency at the measuring probe input too high
Reaction: OFF1 (OFF2)
Acknowledge: IMMEDIATELY
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-629