Siemens SINUMERIK 840D sl Series Diagnostics Manual page 592

Overview of Alarms
Remedy: Perform an NCK reset
Program Con- Internal
tinuation:
111309
Error when selecting tool
Definitions: In the asynchronous subroutine, internal settings in the NC were triggered by the operator
panel. If one of the alarms from 111306 to 111310 occurrs, these settings cannot be car-
ried out.
Reactions: - Alarm display.
Remedy: Perform an NCK reset
Program Con- Internal
tinuation:
111310
Error when selecting zero offset
Definitions: In the asynchronous subroutine, internal settings in the NC were triggered by the operator
panel. If one of the alarms from 11306 to 111310 occurrs, these settings cannot be car-
ried out.
Reactions: - Alarm display.
Remedy: Perform an NCK reset
Program Con- Internal
tinuation:
111311
NC start not possible: Deselect single block
Definitions: A program was activated with block search, while at the same time single block was
active.
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Deselect single block.
Program Con- Internal
tinuation:
111400
Unknown PLC error
Definitions: The PLC has announced an error that is unknown in the operator panel.
Reactions: - NC Start disable in this channel.
- Alarm display.
Remedy: Inform Siemens.
Program Con- Switch control OFF - ON.
tinuation:
111410
Tool %1 was created
Parameters: %1 = Tool number
Definitions: When ManualTurn is booted, a check is run to see whether all standard tools are avail-
able. If this is not the case, the missing tools will be created automatically. If several tools
are created, they will be output in an aggregate signal.
Meaning: Example: %1 Number of the tool that was created,
that were created, 5...16.
Remedy: --
2-592
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
5 %1 First and last tool
© Siemens AG, 2005. All rights reserved
08/2005