Siemens SINUMERIK 840D Diagnostics Manual page 14

1 Alarms
0
Definitions:
Reactions:
Remedy:
Program Continuation:
1000
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1001
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1002
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-14
No (more) alarm(s) present
If the communication (variable service) requests more alarms than currently available in
the alarm list, this alarm is communicated as end-of-program function.
- No alarm reaction.
--
Internal
System error %1
%1 = System error number
With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error.
- NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Make a note of the error text and contact Siemens A&D MC, Hotline
• Tel 0180 / 5050 - 222 (Germany)
• Fax 0180 / 5050 - 223
• Tel +49-180 / 5050 - 222 (International)
• Fax +49-180 / 5050 - 223
• Email techsupport@ad.siemens.de
Switch control OFF - ON.
System error %1
%1 = System error number
With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error.
- Mode group not ready.
- Channel not ready.
- Interface signals are set.
- Alarm display.
Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Clear alarm with the RESET key in all channels of this mode group. Restart part program.
System error %1
%1 = System error number
With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error.
- Alarm display.
Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Clear alarm with the Delete key or NC START.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04