Siemens SINUMERIK 840D Diagnostics Manual page 141

10.04
Reactions:
Remedy:
Program Continuation:
12090
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12100
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12110
Parameters:
Definitions:
Reactions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Correction block
- Interface signals are set.
- Alarm display.
Press the NC Stop key and select the function "Correction block" with the softkey PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
Analyze the block and correct it in accordance with the syntax rules given in the Program-
ming Guide.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 unexpected parameter %3
%1 = Channel number
%2 = Block number, label
%3 = Disallowed parameters in the text
The programmed function has been predefined; no parameters are allowed in its call. The
first unexpected parameter is displayed.
Example: On calling the predefined subroutine TRAFOF (switching off a transformation)
parameters have been transferred (one or more).
- Correction block
- Interface signals are set.
- Alarm display.
Press the NC Stop key and select the function "Correction block" with the softkey PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
Program function without parameter transfer.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 number of passes %3 not permissible
%1 = Channel number
%2 = Block number, label
%3 = Number of passes
The subroutines called with MCALL are modal, i.e. after each block with positional infor-
mation a routine run is automatically performed once. For this reason, programming of the
number of passes under address P is not allowed.
The modal call is effective until another MCALL is programmed, either with a new subrou-
tine name or without (delete function).
- Correction block
- Interface signals are set.
- Alarm display.
Press the NC Stop key and select the function "Correction block" with the softkey PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
Program the subroutine call MCALL without number of passes.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 block syntax cannot be interpreted
%1 = Channel number
%2 = Block number, label
The addresses programmed in the block are not permissible together with the valid syntax
defining G function, e.g. G1 I10 X20 Y30 F1000.
An interpolation parameter must not be programmed in the linear block.
- Correction block
- Interface signals are set.
- Alarm display.
1 Alarms
1-141