Siemens SINUMERIK 840D Diagnostics Manual page 96

1 Alarms
10260
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10261
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10299
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10600
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-96
[up to SW 3.x only] Channel %1
%1 = Channel number
REORG is not possible at present.
- NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
--
Switch control OFF - ON.
Channel %1 communication overload for block preparation
%1 = Channel number
The internal communication between the NCK modules that evaluate the channel-specific
VDI signals (START/STOP/RESET/DDTG/ASUBS/...) and the block preparation are over-
loaded. The block preparation modules are not being allocated enough computing time.
- NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
More processor time must be allocated to the block preparation modules. Machine data
$MN_IPO_SYSCLOCK_TIME_RATIO or $MN_SYSCLOCK_CYCLE_TIME can be
increased for this purpose.
Switch control OFF - ON.
Channel %1 Auto-Repos function is not enabled
%1 = Channel number
The Auto-Repos function (operating mode) was selected in the channel but is not imple-
mented.
- Alarm display.
This message is purely informational.
Clear alarm with the Delete key or NC START.
Channel %1 block %2 auxiliary function during thread cutting active
%1 = Channel number
%2 = Block number, label
An auxiliary function output is programmed in a thread cutting block.
- Alarm display.
Consequential errors can occur if the machining path of the thread block is too short and
further blocks (thread blocks) follow in which no machining stop may occur.
Possible remedial measures:
• Program a longer path and/or a lower traversing rate.
• Output auxiliary function in another block (program section).
Clear alarm with the Delete key or NC START.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04