Siemens SINUMERIK 840D Diagnostics Manual page 87

10.04
Definitions:
Reactions:
Remedy:
Program Continuation:
8082
Definitions:
Reactions:
Remedy:
Program Continuation:
8088
Definitions:
Reactions:
Remedy:
Program Continuation:
8098
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
8100
Parameters:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Options were activated, that are not licensed by the license key entered.
- Alarm display.
Generate and enter license key via Internet.
Clear alarm with the Delete key or NC START.
The license key was entered three times, Power On required before next try.
The license can be entered three times max (correctly or incorrectly).
- Alarm display.
Execute NCK Power On and enter the license key (correctly).
Clear alarm with the Delete key or NC START.
'Selection of non-grinding-specific tools' option not possible
The system version of the software only allows selection of grinding specific tools (i.e.
tools of type 4xx).
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Select a tool of type 4xx (grinding tool)
or install a standard version of the system software
Clear alarm with the RESET key. Restart part program.
Invalid combination of options (%1)
%1 = Bit mask of options
The following restrictions apply to this module for the combination of options:
The option "Two-channel" and the options "External language", "Nibbling", "Neural quad-
rant error compensation" and "Measurement level 2" exclude one another!
Bit0 (LSB): Nibbling
Bit1 : External language
Bit2 : Neural quadrant error compensation
Bit3 : Measurement level 2
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Set the options accordingly.
Switch control OFF - ON.
Channel %1 block %2: function not possible
%1 = Channel number
%2 = Block number, label
1 Alarms
1-87