Siemens SINUMERIK 840D Diagnostics Manual page 289

10.04
Remedy:
Program Continuation:
17150
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17160
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17170
Parameters:
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Please inform the authorized personnel/service department. Use another output or deacti-
vate concurrent NC function via MD.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 maximum of %3 NCK outputs programmable in the block
%1 = Channel number
%2 = Block number, label
%3 = Quantity
No more than the specified number of outputs may be programmed in an NC block.
The quantity of hardware outputs is defined in the MDs:
10360 FASTIO_DIG_NUM_OUTPUTS and
10310 FASTIO_ANA_NUM_OUTPUTS
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Program fewer digital/analog outputs in a block. The specified maximum number applies
in each case separately for analog or digital outputs. If necessary, program two NC
blocks.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 no tool selected
%1 = Channel number
%2 = Block number, label
An attempt has been made to access the current tool offset data via the system variables:
$P_AD [n]: Contents of the parameter (n: 1 - 25)
$P_TOOL: Active D number (tool edge number)
$P_TOOLL [n]: Active tool length (n: 1- 3)
$P_TOOLR: Active tool radius
although no tool had been selected previously.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Program or activate a tool offset in the NC program before using the system variables.
Example:
N100 G.. ... T5 D1 ... LF
With the channel-specific machine data:
Modify MD 22550: TOOL_CHANGE_MODE
New tool offset for M function
Modify MD 22560: TOOL_CHANGE_M_CODE
M function with tool change
It is established whether a tool offset is activated in the block with the T word or whether
the new offset values are allowed for only when the M word for tool change occurs.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 number of symbols too large
%1 = Channel number
%2 = Block number, label
The predefined symbols could not be read in during power-up.
1 Alarms
1-289