Siemens SINUMERIK 840D Diagnostics Manual page 205

10.04
Reactions:
Remedy:
Program Continuation:
14300
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14310
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14320
Parameters:
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 overlaid handwheel motion activated incorrectly
%1 = Channel number
%2 = Block number, label
Handwheel override has been called up incorrectly:
• 1. For positioning axes:
• Handwheel override programmed for indexing axes,
• No position programmed,
• FA and FDA programmed for the same axis in the block.
• 2. For contouring axes:
• No position programmed,
• G60 not active,
• 1. G group incorrect (only G01 to CIP).
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Handwheel %1 configuration incorrect or inactive
%1 = Handwheel number
• The inputs are using a drive with a drive number that does not exist or
• an inactive drive for assignment of the handwheel (ENC_HANDWHEEL_MODULE_NR)
or
• an axis is using a measuring circuit which does not exist for the drive hardware.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department. Check input configuration
(machine data) and/or drive hardware. Power-up is interrupted.
Switch control OFF - ON.
Handwheel %1 used twice (%2) in channel %3 axis %4
%1 = Handwheel number
%2 = Use
%3 = Channel
%4 = Axis
Informational alarm indicating that the mentioned handwheel is used twice:
The second parameter provides the explanation:
1: Block with axial handwheel override for this axis cannot be executed as the handwheel
for this axis performs a DRF movement
2: Block with velocity override of the path cannot be executed as the handwheel performs
a DRF movement for this axis of the path
1 Alarms
1-205