Siemens SINUMERIK 840D Diagnostics Manual page 506

1 Alarms
105041
Definitions:
Remedy:
Program Continuation:
105042
Definitions:
Remedy:
Program Continuation:
105043
Definitions:
Remedy:
Program Continuation:
105050
Definitions:
Remedy:
Program Continuation:
105051
Definitions:
Remedy:
Program Continuation:
105052
Definitions:
Remedy:
Program Continuation:
105053
Definitions:
Remedy:
Program Continuation:
105054
Definitions:
Remedy:
Program Continuation:
1-506
Block number is too large!
The set increment and the size of the program cause the block number to be greater than
999999.
--
Internal
Impermissible block number!
The first block number is less than 0 or greater than 999999.
--
Internal
Impermissible increment!
The increment was entered as a negative.
--
Internal
Please wait: Graphic is being output!
The help displays are being prepared for display.
--
Internal
Output of dynamic long texts for cycle parameterization
The dynamic long texts for the cycle parameterization are output here.
--
Internal
Error in the cycle description of the <xxx>!
The cycle description sc.com, uc.com contains a line that cannot be interpreted.
This line is output via <xxx>.
--
Internal
No cycle available in current line!
The editor's cursor is in a line that does not contain a cycle.
A recompilation is not possible.
--
Internal
Error during cycle description call!
One of the sc.com, cov.com cycle description files contains a non-interpretable parame-
ter.
Initilization of the cycles is aborted.
--
Internal
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04