Siemens SINUMERIK 840D Diagnostics Manual page 85

10.04
Remedy:
Program Continuation:
8037
Definitions:
Reactions:
Remedy:
Program Continuation:
8038
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
8040
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
8041
Parameters:
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
• Buy option
• Do not activate different Ipo or position control cycles (see
MN_IPO_SYSCLOCK_TIME_RATIO and MN_POSCTRL_SYSCLOCK_TIME_RATIO).
Switch control OFF - ON.
Option 'APC activation' not set
Function 'Advanced Positioning Control' (APC) has been activated in the drive, although
the corresponding option was not set.
- NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
• Buy option
• Deactivate function 'Advanced Positioning Control' (APC) in the drive
Switch control OFF - ON.
Option 'activation of more than %1 lead link axes' not set
%1 = Number of axes
The option for the number of lead link axes does not match the number of configured axes
in the MD $MA_AXCONF_ASSIGN_MASTER_NCU.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
• Buy option
• Configure fewer lead link axes
Clear alarm with the RESET key. Restart part program.
Machine data %1 reset, corresponding option is not set
%1 = String: MD identifier
A machine data has been set that is locked by an option.
- Alarm display.
Please inform the authorized personnel/service department. For retrofitting the option,
please refer to your machine manufacturer or to a sales representative of SIEMENS AG,
A&D MC.
Clear alarm with the Delete key or NC START.
Axis %1: MD %2 reset, corresponding option not sufficient
%1 = Axis number
%2 = String: MD identifier
All of the axes selected in the machine data of the assigned option are used. Safety func-
tions have been selected for too many axes in the axial machine data.
The alarm can be reprogrammed in the MD ALARM_REACTION_CHAN_NOREADY
(channel not ready).
1 Alarms
1-85