Siemens SINUMERIK 840D Diagnostics Manual page 307

10.04
Definitions:
Reactions:
Remedy:
Program Continuation:
18101
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
18102
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
18200
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
18201
Parameters:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
The following values are valid at the present time:
0: "Deselect traverse against fixed stop"
1: "Select traverse against fixed stop" valid.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
--
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 invalid value assigned to FXST[]
%1 = Channel number
%2 = Block number, label
Only the range 0.0 - 100.0 is valid at the present time.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
--
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 invalid value assigned to FXSW[]
%1 = Channel number
%2 = Block number, label
Only positive values including zero are valid at the present time.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
--
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 curve table: block search stop not allowed with definition
CTABDEF
%1 = Channel number
%2 = Block number, label
Program instructions that lead to a preprocessing stop are not allowed within a curve
table definition. The system variable $P_CTABDEF can be queried to check whether a
table definition is currently active.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Put the block in parenthesis using "IF NOT($P_CTABDEF) ... ENDIF" or remove the
instruction that causes the preprocessing stop. Then start the part program again.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 curve table: table %3 does not exist
%1 = Channel number
%2 = Block number, label
%3 = Number of curve table
1 Alarms
1-307