Siemens SINUMERIK 840D Diagnostics Manual page 451

10.04
61353
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61354
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61355
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61356
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 Path for log file not found
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE106.
The specified directory does not exist or the specified path is incorrect.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 File for log file not found
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE106.
No name specified for the log file.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Incorrect file type for logfile
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE106.
The file extension for the log file is incorrect.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 File for log file is being used
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE106.
The log file is already used by an NC program.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Clear alarm with the RESET key. Restart part program
1 Alarms
1-451