Siemens SINUMERIK 840D Diagnostics Manual page 439

10.04
61241
Definitions:
Reactions:
Remedy:
Program Continuation:
61242
Definitions:
Reactions:
Remedy:
Program Continuation:
61243
Definitions:
Reactions:
Remedy:
Program Continuation:
61244
Definitions:
Reactions:
Remedy:
Program Continuation:
61246
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2: No retraction plane defined for this machining direction.
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Define more retraction planes.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Wrong machining direction
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check programmed parameters.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Correct tool change point, tool tip is in retraction area!
The tool change point has to be far enough outside the retraction area so that when the
revolver is swivelled, no tool extends into the retraction area.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Specify another tool change point.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Thread lead change results in an undefined thread
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check thread geometry.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Safety clearance too small
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Increase safety clearance.
Internal
1 Alarms
1-439