Siemens SINUMERIK 840D Diagnostics Manual page 465

10.04
Reactions:
Remedy:
Program Continuation:
61807
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61808
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61809
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61810
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Internal
Channel %1 block %2 wrong spindle direction programmed (active)
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE840.
The programmed spindle direction contradicts the spindle direction planned for the cycle.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check parameters SDR and SDAC.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: The final drilling depth or individual drilling depth is missing
%1 = Channel number
%2 = Block number, label
The total depth Z or individual drilling depth Q is missing from theG8xblock (initial cycle
call).
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Internal
Channel %1 block %2: Impermissible drilling position
%1 = Channel number
%2 = Block number, label
--
- Alarm display.
-
Internal
Channel %1 block %2: ISO-G code not possible
%1 = Channel number
%2 = Block number, label
In the call block an impermissible ISO axis name was programmed.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Internal
1 Alarms
1-465