Siemens SINUMERIK 840D Diagnostics Manual page 403

10.04
27203
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
27204
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
27205
Parameters:
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
PROFIsafe: MD %1[%2]: SPL assignment error
%1 = MD name
%2 = MD array index
The parameterization of the specified machine data for the link between the SPL interface
and a PROFIsafe module is incorrect because of the following reasons:
• Exchanged bit limits (upper bit value < lower bit value)
• Bit values greater than definition of SPL interface (bit value > 64)
• Number of bits too high for this PROFIsafe module (upper bit value - lower bit value + 1
> 8)
• No SPL assignment parameterized (both bit values equal to zero)
• Incorrect SPL assignment (bit value equals zero)
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Correct the MD.
Switch control OFF - ON.
PROFIsafe: double assignment MD %1[%2] - MD %3[%4]
%1 = MD name 1
%2 = MD array index for MD name 1
%3 = MD name 2
%4 = MD array index for MD name 2
A double assignment has illegally been parameterized in the specified machine data:
$A_INSE parameterized on DMP as well as PROFIsafe modules. Involved MDs:
• MD $MN_SAFE_IN_HW_ASSIGN
• MD $MN_PROFISAFE_IN_ASSIGN
$A_INSE parameterized on several PROFIsafe modules. Involved MD:
• MD $MN_PROFISAFE_IN_ASSIGN
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Correct the MD.
Switch control OFF - ON.
PROFIsafe: number of signals in MD %1 [%2] <> MD %3[%4]
%1 = MD name 1
%2 = MD array index for MD name 1
%3 = MD name 2
%4 = MD array index for MD name 2
The parameterized number or the signals used must be the same in both machine data.
1 Alarms
1-403