List Of Action Numbers - Siemens SINUMERIK 840D Diagnostics Manual

03.04
1.3
No. 1
Explanation
Not allowed if
Remedy
No. 2
Explanation
Not allowed if
Remedy
No. 3
Explanation
Not allowed if
Remedy
No. 4
Explanation
Not allowed if
Remedy
No. 5
Explanation
Not allowed if
Remedy
No. 6
Explanation
Not allowed if
Remedy
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition

List of action numbers

The following list describes the actions stated in the alarm texts under "Action %.."
according to their numbers.
Run Init phase (tasks are initialized after power on).
-
-
Perform reset (VDI signal: Reset, mode group reset or after power on).
-
-
Activate Reset Init blocks (VDI signal: Reset).
-
-
Perform reset, end of program has been detected (NC block with M30).
-
-
Change the mode to the MDA or AUTOMATIC program operating mode
(VDI signal: Mode group).
1. The channel is active (program running, block search, loading machine data).
2. Startup has already been performed in the other program operating mode.
3. A channel has exited the mode group due to an interrupt.
4. Overstore or digitizing has been selected.
> Abort the program (Reset key) or stop the program (not with block search, loading
machine data).
> Abort the program (Reset key).
> Abort the program with the Reset key or wait until the interrupt has finished.
> Deactivate overstore/digitizing.
Automatic change from an internal mode to the mode set externally (with TEACH_IN, an
attempt is made after every stop to change from the internal mode "AUTOMATIC, MDA"
to TEACH_IN).
-
-
1 Alarms
1-665