Error Codes Of Alarm 300500 - Siemens SINUMERIK 840D Diagnostics Manual

1 Alarms
No. 109
Explanation
Not allowed if
Remedy
No. 115
Explanation
Not allowed if
Remedy
No. 116
Explanation
Not allowed if
Remedy
No. 117
Explanation
Not allowed if
Remedy
No. 118
Explanation
Not allowed if
Remedy
1.4
Error code
Error text
Extension 1
Extension 2
Explanation
Remedy
Error code
Error text
Extension 1
1-678
Deactivate: Axis is now controlled by the PLC (VDI signal).
The axis is not controlled by the PLC. Not for all axis types at present.
-
The event is triggered by the positive PLC edge of the signal "Repos-Mode-Edge".
The channel is active (program running, block search, loading machine data).
> Abort the program with the Reset key or stop the program (not with block search, load-
ing machine data).
Activate tool-management commands (Ch. VDI signal).
The NCK channel is in a state other than "ready".
> Abort the program or process with the Reset key or wait for end of program.
Deactivate tool-management commands (Ch. VDI signal).
The NCK channel is in a state other than "ready".
> Abort the program or process with the Reset key or wait for end of program.
Selection of desired safety limitations (SGE) (always allowed).
-
-

Error codes of alarm 300500

After the error codes 1 listed below, an error code 2 may be specified. This must be inter-
preted as the hexadecimal number of the terminal block/module.
0001H
Error in P:-RAM
-
Incorrect address
When the program memory was being tested during power-up, it was detected that the
written bitmap could not be read back.
Cause: Hardware error on control module.
Error only occurs with drive software V1.x (EPROM version). The error has been replaced
by system errors F034 and F035 in subsequent download versions.
Replace the control module.
0002H
Error in X: or Y:-RAM
-
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
03.04