Siemens SINUMERIK 840D Diagnostics Manual page 221

10.04
14730
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14740
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14745
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14750
Parameters:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 conflict at activation of centerless transformation
%1 = Channel number
%2 = Block number, label
• Centerless transformation may not be activated when:
• G96 is active and regulating spindle is also master spindle.
• Regulating spindle is in interdependent grouping.
• Axes of centerless transformation overlap with an active transformation and a tool is
active.
• For grinding or for regulating wheel spindle, tools are active that are not centerless tools
(T1, T2).
• Constant wheel peripheral speed for the regulating spindle is active.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
• Modify part program.
• Check tool data.
• Check machine data.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 no tool data available for centerless grinding
%1 = Channel number
%2 = Block number, label
For centerless grinding, the tool data must be contained in T1, D1 (grinding wheel) or
T2,D1 (regulating wheel). An error has been found here.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
• Modify part program.
• Check tool data.
• Check machine data.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 centerless grinding not active
%1 = Channel number
%2 = Block number, label
An attempt has been made to switch off the centerless grinding function even though it
was not active.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Modify part program.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 too many auxiliary functions programmed
%1 = Channel number
%2 = Block number, label
1 Alarms
1-221