Siemens SINUMERIK 840D Diagnostics Manual page 283

10.04
Reactions:
Remedy:
Program Continuation:
16957
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17000
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17001
Parameters:
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Alarm display.
Delete the "Global start disable" and restart.
Clear alarm with the Delete key or NC START.
Channel %1 Stop-Delay area is suppressed
%1 = Channel ID
The program area (Stop-Delay area), which is put into brackets through DELAYFSTON
and DELAYFSTOF, could not be activated. Every stop therefore becomes effective imme-
diately and is not delayed!
This occurs every time, when braking into a stop Stop-Delay area, i.e. a braking process
starts before the Stop-Delay area and ends not earlier than in the Stop-Delay area.
If the Stop-Delay area is entered with override 0, the Stop-Delay area
can also not be activated (example: a G4 before the Stop-Delay area allows the user
to reduce the override to 0 and the next block in the Stop-Delay area
then starts with override 0 and the alarm situation described occurs.)
$MN_ENABLE_ALARM_MASK Bit-7 switches on this alarm.
- Interface signals are set.
- Alarm display.
$MN_STOP_MODE_MASK and language command DELAYFSTON DELAYFSTOF
Alarm display showing cause of alarm disappears. No further operator action necessary.
Channel %1 block %2 maximum number of symbols exceeded
%1 = Channel number
%2 = Block number, label
The maximum number of symbols defined by machine data 28020
MM_NUM_LUD_NAMES_TOTAL has been exceeded.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department.
• Modify machine data
• Reduce the number of symbols (variables, subroutines, parameters)
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 no memory left for tool/magazine data
%1 = Channel number
%2 = Block number, label
The number of the following tool/magazine data sizes in the NC is given by machine data:
• Number of tools + number of grinding data blocks: 18082 MM_NUM_TOOL
• Number of cutting edges: 18100 MM_NUM_CUTTING_EDGES_IN_TOA
Tools, grinding data blocks, cutting edges can be used independently of the tool manage-
ment function.
The memory for the following data is available only if the corresponding bit in 18080
MM_TOOL_MANAGEMENT_MASK has been set.
• Number of monitoring data sets: 18100 MM_NUM_CUTTING_EDGES_IN_TOA
1 Alarms
1-283