Siemens SINUMERIK 840D Diagnostics Manual page 273

10.04
16926
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16927
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16928
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 channel coordination: action %2 not allowed in block %3, marker %4 is
already set
%1 = Channel number
%2 = Action
%3 = Block number
%4 = Marker number
The action was denied, the marker was already set. Check the program.
Example:
SETM(1) ; CLEARM(1) ; Marker must be reset first.
SETM(1)
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Repeat action.
Clear alarm with the RESET key. Restart part program
Channel %1 action %2<ALNX> at active interrupt treatment not allowed
%1 = Channel number
%2 = Action number/action name
This action may not be activated during interrupt processing (e.g. mode change).
- Alarm display.
Reset or wait until interrupt processing is terminated.
Clear alarm with the Delete key or NC START.
Channel %1 interrupt treatment: action %2<ALNX> not possible
%1 = Channel number
%2 = Action number/action name
A program interrupt has been activated in a non REORG capable block.
Examples of possible program interrupt in this case:
• Traversing to fixed stop
• VDI channel delete distance-to-go
• VDI axial delete distance-to-go
• Measuring
• Software limit
• Axis replacement
• Axis from correction
• Servo disable
• Gear stage change at actual gear stage unequal to setpoint gear stage.
The relevant block concerns a:
• Pick-up block during block search (excluding last pick-up block)
• Block in overstore interrupt.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Do not trigger the event on this block.
Clear alarm with the RESET key. Restart part program
1 Alarms
1-273