Siemens SINUMERIK 840D Diagnostics Manual page 262

1 Alarms
16780
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16781
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16782
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16783
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-262
Channel %1 block %2 following spindle/axis missing
%1 = Channel number
%2 = Block number, label
The following spindle/axis has not been written in the part program.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 master spindle/axis missing
%1 = Channel number
%2 = Block number, label
The master spindle/axis has not been programmed in the part program.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 following spindle/axis %3 not available
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
A coupling has been switched on in which the slave spindle/axis is currently not available.
Possible causes:
• The spindle/axis is active in the other channel.
• The spindle/axis has been accessed by the PLC and has not yet been released.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department. Put the master spindle/axis
with spindle/axis exchange into the necessary channel or release from the PLC.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 master spindle/axis %3 not available
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
A coupling has been switched on in which the master spindle/axis is currently not avail-
able. Possible causes:
• Setpoint linkage has been selected and spindle/axis is active in the other channel.
• The spindle/axis has been accessed by the PLC and has not yet been released.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department. Put the master spindle/axis
with spindle/axis exchange into the necessary channel or release from the PLC.
Clear alarm with NC START or RESET key and continue the program.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04